Installation

1. INSTALL COMPRESSOR
(a) Install the stud bolt.
Torque: 26 N.m (265 kgf.cm, 19 ft.lbf)
(b) Install the compressor with 4 bolts and the nut.
Torque: 52 N.m (530 kgf.cm, 38 ft.lbf)
(c) Connect the connector.

2. INSTALL DRIVE BELT

3. INSTALL ENGINE UNDER COVER

4. CONNECT DISCHARGE HOSE AND SUCTION HOSE TO COMPRESSOR
Torque: 25 N.m (250 kgf.cm, 18 ft.lbf)

HINT: Lubricate 2 new O-rings with compressor oil and install the tubes.

5. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY
6. EVACUATE AIR IN REFRIGERATION SYSTEM AND CHARGE WITH REFRIGERANT
Discharging & Evacuating System

Specified amount:
950 ± 50 g (33.51 ± 1.76 oz)

7. INSPECT FOR LEAKAGE OF REFRIGERANT
Leak Testing the System
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.

8. INSPECT A/C OPERATION