Rear

REMOVAL
1. Remove the 4 nuts and both stabilizer bar links.

Installation Hint: Torque to 65 Nm (48 ft. lbs.)

2. Remove the 4 bolts and both stabilizer bar brackets.

Installation Hint: Torque to 18 Nm (13 ft. lbs.)

3. Remove both bushings.

INSPECTION
1. Flip the ball joint stud back and 4 - 5 times before: installing the nut.
2. Using a torque wrench, turn the stud continuously one turn every 2 - 4 seconds and take the torque reading on the 5th turn. Torque (turning): 0.05 - 1.5 Nm (0.4 - 13 inch lbs.)

INSTALLATION
^ Installation is in the reverse order of removal.