Service Specifications

Head Surface Of Block Warpage
Maximum 0.07 mm (0.0028 in)

Cylinder Bore Diameter:

NOTE: Bore diameter mark is stamped into the block below the bore on the left side of the block and above the bore on the right side.

Standard:
Mark "1" 87.500 - 87.510 mm (3.4449 - 3.4453 in)
Mark "2" 87.510 - 87.520 mm (3.4453 - 3.4457 in)
Mark "3" 87.520 - 87.530 mm (3.4457 - 3.4461 in)

Maximum 87.730 mm (3.4539 in)


Main Bearing Cap Stud Bolt Tension Portion Diameter:
Standard 7.500 - 7.600 mm (0.2953 - 0.2992 in)
Minimum 7.400 mm (0.2913 in)

Piston Oil Clearance:
Standard 0.080 - 0.100 mm (0.0031 - 0.0039 in)
Minimum 0.120 mm (0.0047 in)