Glass Printed Antenna

NOTE: The glass printed antenna is serviced in the same manner as the rear defogger wire, shown below.

REPAIR DEFOGGER WIRES





a. Clean the broken wire tips with a grease. wax and silicone remover. a
b. Place the masking tape along both sides of the wire to be repaired.
c. Thoroughly mix the repair agent (DuPont paste No. 4817).





d. Using a fine tip brush, apply a small amount to the wire.
e. After a few minutes, remove the masking tape.
f. Allow the repair to stand at least 24 hours.