Interior Light System

LOCATION

INSPECTION







1. INSPECT PERSONAL LIGHT SWITCH CONTINUITY
If continuity is not as specified, replace the light assembly or bulb.







2. INSPECT PERSONAL LIGHT SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If the circuit is as specified, inspect power source or wire harness.







3. INSPECT INTERIOR LIGHT SWITCH CONTINUITY
If continuity is not as specified, replace the light assembly or bulb.







4. INSPECT INTERIOR LIGHT SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If the circuit is not as specified, inspect power source or wire harness.







5. INSPECT VANITY LIGHT CONTINUITY
If continuity is not as specified, replace the bulb or vanity light.







6. INSPECT VANITY LIGHT SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If the circuit is not as specified, inspect power source or wire harness.




7. INSPECT DOOR COURTESY SWITCH CONTINUITY
a. Check that there is continuity between terminals and the switch body with the switch ON (switch pin released: opened door).
b. Check that there is no continuity between terminals and the switch body with the switch OFF (switch pin pushed in: closed doors).
If operation is not as specified, replace the switch.







8. INSPECT DOOR COURTESY SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If the circuit is not as specified, inspect power source or wire harness.