Installation

1. Install No.2 cooling fan to radiator.
Install the 3 bolts and cooling fan.
Torque: 5.0 Nm (44 in.lb)
2. Install No.1 cooling fan to radiator.
Install the 2 bolts and cooling fan.
Torque: 5.0 Nm (44 in.lb)

Number 1 Engine Coolant Temperature Switch:

3. Install No.1 Engine Coolant Temperature (ECT) switch.



4. Install lower radiator hose to radiator.
5. Install A/T oil cooler hoses to radiator.
6. Install radiator and cooling fans assembly.
(a) Install the 2 lower supports.
(b) Install the radiator and cooling fans assembly, then lower in the radiator.



(c) Install the 2 bolts and 2 upper supports.
Torque: 12.8 Nm (9 ft.lb)

7. Connect No.1 ECT switch wire connector.
8. Connect No.1 and No.2 cooling fan connectors.
9. Connect A/T oil cooler hoses to oil cooler pipes.
10. Connect lower radiator hose to water inlet pipe.
11. Connect upper radiator hose to radiator.
12. CANADA: Connect relay block (for daytime running light system) to battery holddown clamp.
13. Fill with engine coolant.

NOTE:
- Start the engine, and check for coolant and A/T fluid leaks.
- Check the A/T fluid level.
- Refer to Transmission and Drivetrain.