ABS W/Traction Control (TRAC)

1. Turn the Ignition Switch OFF.

DLC Connector Diagnostic Terminal ID:

2. Using Special Service Tool (SST 09843-18020), connect terminals Ts and E1 of DLC1.
3. Start the engine.

ABS Warning Light Flashing "Normal" Code:

4. Check that the ABS Warning Light blinks.

NOTE: If the ABS Warning Light does not blink, inspect the ABS Warning Light circuit. ABS Warning Light Circuit

5. Drive vehicle faster than 45 km/h (28 mph) for several seconds.
6. Stop the vehicle.
7. Using SST, connect terminals Tc and E1 of DLC1.
8. Read the number of blinks of the ABS Warning Light.

Malfunction Code Flash Sequence:

NOTE:
^ Refer to Diagnostic Trouble Code Descriptions for explanation of codes. ABS (Antilock Brake System)
^ If every sensor is normal, a normal code is output (A cycle of 0.25 sec. ON and 0.25 sec. OFF is repeated).
^ If 2 or more malfunction are indicated at the same time, the lowest numbered code will be displayed 1st.

9. After doing the check, disconnect the SST from terminals Ts and E1, Tc and E1 of DLC1, and turn Ignition Switch OFF.