Dash Under Cover - Loose/Falling Down
BODYBO006-97
September 5, 1997
Title:
DASH UNDER COVER LOOSE/FALLING
Models;
'97 ES 300
Introduction
Some ES 300 models may experience the lower dash under cover (below glove compartment) coming loose and/or falling off. The main engine wire harness routing was modified to prevent excessive down force on the under cover.
Production Change Information
^ 1997 ES 300s starting with VINs JT8BF22G * V0039230
Warranty Information
Applicable Warranty:
This repair is covered under the Lexus Comprehensive Warranty. This warranty is in effect for 48 months or 50,000 miles, whichever occurs first, from the vehicle's in-service date.
Repair Procedure
NOTE:
Refer to the ES 300 Repair Manual (Page RS-19) in addition to the illustrations below.
1. Remove the lower dash under cover (No.2 Under Cover), front door scuff plate and glove compartment assembly (Lower Instrument Panel) as shown in the repair manual.
NOTE:
DO NOT disconnect yellow SRS Junction Block.
2. Move the Engine Control Module (ECM) to the right in order to gain clearance between the blower unit junction block and the ECM.
3. Reposition the engine wire harness by lifting it up between the ECM and the blower unit. Position the engine wire harness on the right side end of the blower junction block as shown.
4. If necessary, move the ECM back to its original position.
5. Reinstall the glove compartment assembly, front door scuff plate and clip the SRS junction connector back into position on the lower dash under cover (No.2 Under Cover). Carefully reinstall the lower dash cover, taking care that the rear locating pin and the right rear locating tab are correctly positioned.