Procedure C - Wireless Inoperative at Specific Locations:

PROCEDURE C - WIRELESS INOPERATIVE AT SPECIFIC LOCATIONS:

This procedure is used to check for the presence of electrical interference at specific locations that may interfere with wireless transmitter/receiver operation. This test is used only to verify the presence of electrical interference at a specific location and does not lead to a repair.

IMPORTANT: Verify that the wireless door lock control system operation is normal in non-compliant areas. If the system is inoperative at all locations, do not continue with this procedure, refer to Procedure A - Wireless Inoperative At All Times.

Perform the following procedure in the area where the problem is occurring:

1. Enter the diagnostic mode:

a. Open the driver's door.

b. Lock all doors using the interior power door lock switch.

c. Insert key in ignition once and remove.





d. Cycle the door locks (unlock and lock = 1 cycle) using the interior power door lock switch 10 times as shown (if door locks are cycled too slow or too fast, diagnostic mode will not be initiated).

2. Door locks should cycle (unlock/lock) one time automatically to confirm that diagnostic mode has been entered. If door locks do not cycle, repeat Step 1.





3. Within the next 10 seconds, count the number of door lock (unlock/lock) cycles and refer to the chart.