Overdrive (O/D) Direct Clutch Speed Sensor

REPLACEMENT
1. Disconnect Overdrive (O/D) direct clutch speed sensor connector.
2. Remove O/D direct clutch speed sensor, as follows:





a. Remove the bolt and O/D direct clutch speed sensor.
b. Remove the O-ring from the O/D direct clutch speed sensor.
3. Install O/D direct clutch speed sensor, as follows:
a. Coat a new O-ring with Automatic Transmission Fluid (ATF) and install it to the O/D direct clutch speed sensor.
b. Install the O/D direct clutch speed sensor to the transmission case Left Hand (LH) side and torque the bolt.
Torque: 5.4 Nm (48 inch lbs.).
4. Connect O/D direct clutch speed sensor connector.