Knock Sensor: Testing and Inspection

1. REMOVE STARTER





2. REMOVE PS PUMP REAR STAY
3. REMOVE KNOCK SENSORS
- Disconnect the knock sensor connector.
- Using SST, remove the knock sensor. SST 09816-30010
4. INSPECT KNOCK SENSORS
- Using an ohmmeter, check that there is no continuity between the terminal and body.
- If there is continuity. replace the sensor.





5. REINSTALL KNOCK SENSORS
- Using SST, install the knock sensor.
SST 09816-30010

Torque: 44 N.m (450 kgf.cm, 33 ft.lb.)

- Connect the knock sensor connector.

6. REINSTALL PS PUMP REAR STAY

Torque: 39 N.m (400 kgf.cm, 29 ft.lb.)

7. REINSTALL STARTER