Installation

1. INSTALL LOWER HIGH-TENSION CORD COVER.
- Install the high-tension cord cover with the bolt.





2. INSTALL RH HIGH-TENSION CORD CLAMPS.
- Install the cord clamp to the front high-tension cord clamp.





- Install the front and rear high-tension cord clamps with the 2 bolts.

HINT: Place the front and rear ends of the front high- tension cord clamp on the rear high-tension cord clamp and lower high-tension cord cover.





3. INSTALL LH HIGH-TENSION CORD CLAMPS.
- Install the cord clamp to the front high-tension cord clamp.





- Install front and rear high-tension cord clamps with the 2 bolts.

HINT: Place the front and rear ends of the front high - tension cord clamp on the rear high-tension cord clamp and lower high-tension cord cover.

4. INSTALL HIGH-TENSION CORDS.
- Connect the high-tension cords to the spark plugs and distributor caps.





- Secure the high-tension cords with the cord clamps as shown in the image above.





- Connect the high-tension cords to the ignition coils.
- Set the angle of the grommet as shown in the illustration.
- Align the spline of the ignition coil with the spline of the holder.
- Install the grommet and holder to the ignition coil until the claw of the holder locks securely.





- Check that the lock claw of the holder is engaged by lightly pulling the holder.





NOTICE: Check that holder is correctly installed to the grommet and ignition coil as shown in the illustration.





5. INSTALL RH NO.3 TIMING BELT COVER.
- Install the 3 gaskets to the timing belt cover.
- Fit the portion A of the timing belt cover. matching it with the lower high-tension cord cover.
- Install the timing belt cover with the 4 bolts.





6. INSTALL LH NO.3 TIMING BELT COVER.
- Install the 3 gaskets to the timing belt cover.
- Install the cord grommet to the high-tension cord (from the LH ignition coil).
- Install the cord grommet to the timing belt cover.
- Fit the portion A of the timing belt cover, matching it with the lower high-tension cord cover.
- Install the timing belt cover with the 4 bolts.





7. INSTALL RH ENGINE WIRE COVER.
- Fit portions A and B of the engine wire cover, matching them with the lower high-tension cord cover and No.3 timing belt cover.
- Install the timing belt cover with the bolt.





8. INSTALL LH ENGINE WIRE COVER.
- Connect portions A and B of the engine wire cover to the wire brackets.
- Set the VSV (for the fuel pressure) wire in original position.
- Fit portions C and D of the engine wire cover, matching them with the lower high-tension cord cover and No.3 timing belt cover.
- Install the timing belt cover with the 2 bolts.





9. INSTALL UPPER HIGH-TENSION CORD COVER.
- Fit portion A of the upper high-tension cord cover matching the top of the lower high-tension cord cover.





- Push the front side of the upper high-tension cord cover, and fit the front side claw groove of the upper high-tension cord cover to the claw of the lower high -tension cord cover.
- Install the upper high-tension cord cover with the 2 bolts.





10. INSTALL INTAKE AIR CONNECTOR.
- Connect the end portions of the intake air connector to the throttle body and air cleaner hose.
- Tighten the 2 hose clamps.
- Install the bolt holding the intake air connector to the cylinder head cover.





- Connect the following hoses:
- Air hose to IAC valve
- Air hose (from air control valve on PS pump) to intake air connector
11. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY.
12. CHECK THAT ENGINE STARTS.