Transmission Position Sensor/Switch: Service and Repair

REPLACEMENT




1. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
2. REMOVE PARK/NEUTRAL POSITION SWITCH
- Remove the clip from the shift control cable.




- Remove the nut and control cable.




- Remove the transaxle control shaft lever.
- Remove the park/neutral position switch.
- Inspect the park/neutral position switch.
3. INSTALL AND ADJUST PARK/NEUTRAL POSITION SWITCH




- Install the park/neutral position switch.




- Adjust the park/neutral position switch.




- Install the transaxle control shaft lever.




- Install the control cable and nut.

Torque: 15 Nm (11 ft lb)

- Install the clip to the shift control cable.




4. CONNECT PARK / NEUTRAL POSITION SWITCH CONNECTOR
5. TEST DRIVE VEHICLE