Crankshaft Position Sensor: Service and Repair

PROCEDURE

Removal

1. Disconnect negative terminal cable from battery.

CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.

2. Remove engine under cover.
3. Disconnect crankshaft position sensor connector.





4. Remove the bolt and crankshaft position sensor.

Installation





1. Install the crankshaft position sensor with the bolt.

Torque: 6.4 N.m (56 in lb)

2. Connect crankshaft position sensor connector.
3. Install engine under cover.
4. Connect negative terminal cable to battery.