Removal
PROCEDURE1. Disconnect negative terminal cable from battery.
CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.
2. Drain engine coolant.
3. Remove lower high-tension cord cover.
4. Remove righthand ignition coil.
- Disconnect the ignition coil connector.
- Remove the 2 bolts and disconnect the ignition coil.
5. Disconnect the following hoses:
- Upper radiator hose from front water bypass joint (1)
- Lower radiator hose from water inlet (2)
- Radiator reservoir hose from water inlet housing (3)
6. Remove water inlet and inlet housing.
- Disconnect the water bypass hose from the water inlet housing.
- Remove the 2 bolts holding the water inlet housing to the water pump.
- Pull out the water inlet and inlet housing assembly.
- Remove the 0-ring from the water inlet housing.
7. Remove engine coolant temperaure sensor.
- Disconnect the engine coolant temperaure sensor connector.
- Remove the engine coolant temperaure sensor and gasket.