Removal and Installation

1. Using brake hose wrench 09751-36011 or equivalent and spanner, disconnect brake tube from hose.
2. Remove clip from flexible hose and disconnect hose from cylinder.
3. Remove caliper bolts, then the caliper.
4. Remove brake pads as previously described.
5. Reverse procedure to install, noting the following:
a. Torque caliper bolts to 25 ft. lbs.
b. Torque flexible hose to 17 ft. lbs.
c. Torque brake tube to 11 ft. lbs.
d. Ensure flexible hose is not twisted.
e. Fill reservoir, bleed brakes and check for leaks.