Clearing Trouble Codes

CANCELLING DIAGNOSTIC CODE
Diagnostic codes can be cancelled by carrying out either operation 1. or 2. below.





1. With the ignition switch off, remove the ECU-B fuse in the J/B No.1 for ten seconds or longer.





2. With the ignition switch off, using SST, connect height control connector terminal 9 (terminal CLE) and 8 (terminal E) while at the same time connecting terminals Ts and E1 in the check connector. Maintain this state for 10 seconds or longer, then turn ignition switch on and disconnect the terminals.

SST 09843-18020