Technical Instructions For Campaign # 902 Stop Lamp

SPECIAL SERVICE CAMPAIGN # 902 - CENTER HIGH MOUNTED STOP LAMP

TECHNICAL INSTRUCTIONS

Note: Before performing this repair, be sure to place a protective cover over the rear seat and headrests.

Tools Required

Snap on Trim Tool # A161A or equivalent Small Flat Blade Screwdriver/Needle Nose Plier # 2 Phillips Screwdriver Protective Cloth Cardboard

Removal of High Mount Stop Lamp
1. Insert a thin cloth between rear window glass and high mount stop lamp to protect the defroster grid.

2. Separate the woofer speaker cover from the package tray trim. (Use the trim panel removal tool and insert and lift in the locations shown by the white arrows in the illustration.)
Note: Place cardboard over the exposed speaker.

3. Disconnect the electrical connector. Remove woofer speaker cover.

Note: Be careful not to press the brake pedal while the connector is disconnected.

Inspect

1. Check letters embossed on lamp housing (indicated by black arrow). If the letters are "PA", reinstall the original lamp assembly. If the letters are "PP", replace the lamp assembly with a new one.

Replace

1. Remove the three screws and separate the high mount stop lamp from the woofer speaker cover. Use care when installing new lamp assembly as the lens is a tight fit in the woofer speaker cover.

Installation

Follow the removal procedure in reverse order to carry out installation.
Note: Be sure wire harness/connector does not interfere with the woofer speaker flange.