Removal

Air Cleaner Cover:

Preparation
- Remove air cleaner and battery cover.
- Disconnect negative battery cable.
- Drain coolant into an approved container.

No. 2 Air Cleaner Hose:

- Remove No. 2 air hose.
- Disconnect air flow sensor electrical connector.

Air Cleaner:

- Remove air intake pipe from air flow meter.
- Remove air cleaner lid and air flow meter.

Intake Air Pipe:

Throttle Body Removal
- Remove idle speed control air hose.
- Remove power steering idle-up hose.

Intake Air Pipe:

- Remove air intake tube.

Throttle Body Cables:

- Remove cables from throttle body.

Throttle Body Hoses:

- Disconnect vacuum hoses from throttle body.
- Disconnect vacuum hose from fuel pressure regulator.
- Remove upper ignition wire cover.
- Disconnect water bypass hose from ISC valve.
- Disconnect throttle position sensor electrical connector.
- If equipped with traction control, disconnect sub-throttle position sensor and throttle valve actuator.

Throttle Body Fasteners:

- Remove throttle body fasteners.
- Slide throttle away from intake air chamber.

PCV And No.1 Water Bypass Lines:

- Remove PCV hose.
- Remove water bypass hose.
- Remove throttle body.

PCV And No.1 Water Bypass Lines:

- Remove PCV hose.
- Remove water bypass hoses.