Installation

Cold Start Injector:

- Clean intake manifold and intake air chamber of any gasket material.
- Using a new gasket, install cold start valve.

Torque value - 43 in.lbs (4.9 Nm)

Cold Start Injector Line:

- Using a new gasket, install injector supply line.

Torque value - 11 ft.lb (15 Nm)

Air Intake Chamber:

- Using a new gasket, install intake air chamber.

Torque value - 13 ft.lb (18 Nm)

- Reverse remainder of removal procedure to complete, noting the following torque values:

EGR pipe - 13 ft.lb (18 Nm)
Throttle body - 13 ft.lb (18 Nm)