Reassembly

DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: REASSEMBLY

1. INSTALL NO. 2 CENTER SUPPORT BEARING ASSEMBLY (for Front Side)

(a) Set the No. 2 center support bearing assembly on the intermediate shaft as shown in the illustration.

NOTICE:
Make sure to install the bearing in the correct position.





Text in Illustration





(b) Install a new washer to the intermediate shaft.

(c) Align the matchmarks on the front flange and shaft, and place the front flange on the shaft.





Text in Illustration





(d) Using SST to hold the front flange, press the No. 2 center support bearing assembly into position by tightening a new nut and the washer.

SST : 09330-00021

Torque : 182 Nm (1852 kgf-cm, 134 ft-lbf)





Text in Illustration





(e) Loosen the nut.

(f) Tighten the nut again.

Torque : 69 Nm (701 kgf-cm, 51 ft-lbf)

(g) Using a chisel and a hammer, stake the nut.





2. INSTALL NO. 2 CENTER SUPPORT BEARING ASSEMBLY (for Rear Side)

(a) Set the No. 2 center support bearing assembly on the shaft as shown in the illustration.

NOTICE:
Make sure to install the bearing in the correct position.





Text in Illustration





(b) Install a new washer to the intermediate shaft.

(c) Align the matchmarks on the rear flange and intermediate shaft, and place the flange on the shaft.





Text in Illustration





(d) Using SST to hold the front flange, press the No. 2 center support bearing assembly into position by tightening a new nut and the washer.

SST : 09330-00021

Torque : 182 Nm (1852 kgf-cm, 134 ft-lbf)





Text in Illustration





(e) Loosen the nut.

(f) Tighten the nut again.

Torque : 69 Nm (701 kgf-cm, 51 ft-lbf)

(g) Using a chisel and a hammer, stake the nut.





3. INSTALL REAR PROPELLER SHAFT

(a) Align the matchmarks on the intermediate shaft and rear propeller shaft, and then install the 2 washers and 6 bolts.





Text in Illustration





(b) Using a hexagon wrench (6 mm), temporarily tighten the 6 bolts.

4. INSTALL PROPELLER SHAFT

(a) Align the matchmarks on the propeller shaft and front flange.





Text in Illustration





(b) Install the propeller shaft to the front flange with the 4 bolts, 4 washers and 4 nuts.

Torque : 74 Nm (750 kgf-cm, 54 ft-lbf)

(c) Check that each joint of the propeller with center bearing shaft assembly is facing the direction shown in the illustration.