Replacement

AXLE AND DIFFERENTIAL: REAR DIFFERENTIAL CARRIER OIL SEAL: REPLACEMENT

1. REMOVE NO. 1 REAR DIFFERENTIAL SUPPORT

Removal

2. SEPARATE ELECTRO MAGNETIC CONTROL COUPLING WIRE HARNESS Disassembly

3. REMOVE CONNECTOR BRACKET

(a) Remove the bolt and connector bracket.





(b) Remove the clamp from the connector bracket.

4. REMOVE ELECTRO MAGNETIC CONTROL COUPLING SUB-ASSEMBLY Disassembly

5. REMOVE CONICAL SPRING WASHER Disassembly

6. REMOVE SPACER Disassembly

7. REMOVE DIAPHRAGM OIL SEAL

(a) Using SST, remove the diaphragm oil seal from the rear differential carrier assembly.





Text in Illustration





SST : 09308-00010

8. INSTALL DIAPHRAGM OIL SEAL

(a) Using SST and a press, install a new diaphragm oil seal into the rear differential carrier assembly.





Text in Illustration





SST : 09506-35010

SST : 09554-22010

NOTICE:
* Install the diaphragm oil seal uniformly.
* Press fit the diaphragm oil seal straight.

Distance (A):

0.7 to 1.3 mm (0.0276 to 0.0512 in.)

(b) Apply a light coat of MP grease to the lip of the new diaphragm oil seal.

9. INSTALL SPACER Reassembly

10. INSTALL CONICAL SPRING WASHER Reassembly

11. INSTALL ELECTRO MAGNETIC CONTROL COUPLING SUB-ASSEMBLY Reassembly

12. INSTALL CONNECTOR BRACKET

(a) Install the connector bracket to the rear differential carrier with the bolt.





Torque : 20 Nm (200 kgf-cm, 14 ft-lbf)

13. INSTALL ELECTRO MAGNETIC CONTROL COUPLING WIRE HARNESS Reassembly

14. TEMPORARILY TIGHTEN NO. 1 REAR DIFFERENTIAL SUPPORT

Installation