Replacement

AXLE AND DIFFERENTIAL: DIFFERENTIAL MOUNT CUSHION: REPLACEMENT

1. REMOVE DIFFERENTIAL CARRIER ASSEMBLY WITH DIFFERENTIAL SUPPORT

HINT
Refer to the procedure up to Remove Differential Carrier Assembly with Differential Support Removal.

2. REMOVE REAR DIFFERENTIAL MOUNT CUSHION

(a) Using SST, remove the rear differential mount cushion.





SST : 09570-48010

NOTICE:
* Apply grease to the threads of the SST bolts before use.
* Do not set SST in the wrong direction.
* Be sure to use SST in the correct combination.
* Do not bring SST into contact with the rear suspension member.
* Do not slant the SST bolts.
* Tighten the 2 SST bolts equally into the 2 rear differential mount cushion holes.

3. INSTALL REAR DIFFERENTIAL MOUNT CUSHION

(a) Using SST, install a new rear differential mount cushion.





Text in Illustration





SST : 09570-48010

(A):

9.8 to 10.8 mm (0.386 to 0.425 in.)

(B):

+/- 3°

NOTICE:
* Apply grease to the threads of the SST bolts before use.
* Do not set SST in the wrong direction.
* Be sure to use SST in the correct combination.
* Install the rear differential mount cushion within +/- 3° from the center.
* Temporarily install the rear differential mount cushion to the rear suspension member before installing SST to prevent the rear differential mount cushion from being tilted.
* Install the rear differential mount cushion so that the protrusion is positioned as shown in the illustration.
* Make sure that SST contacts the entire rear differential mount cushion seating surface.
* Do not slant the SST bolts.
* Tighten the 2 SST bolts equally into the 2 rear differential mount cushion holes.

4. TEMPORARILY TIGHTEN DIFFERENTIAL CARRIER ASSEMBLY WITH DIFFERENTIAL SUPPORT

HINT
Refer to the procedure from Temporarily Tighten Differential Carrier Assembly with Differential Support Installation.