Replacement

U660F AUTOMATIC TRANSMISSION / TRANSAXLE: DIFFERENTIAL OIL SEAL (for LH Side): REPLACEMENT

1. REMOVE FRONT WHEEL

2. REMOVE FRONT FENDER APRON SUB-ASSEMBLY LH

(a) Remove the 2 bolts, clip and front fender apron sub-assembly LH.

3. DRAIN AUTOMATIC TRANSAXLE FLUID

(a) Remove the refill plug and gasket from the automatic transaxle.

(b) Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle.

(d) Drain automatic transaxle fluid from the automatic transaxle.

(e) Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle.

Torque : 1.7 Nm (17 kgf-cm, 15 in-lbf)

(f) Using a 6 mm hexagon socket wrench, install a new gasket and the overflow plug to the automatic transaxle.

Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

(g) Temporarily install the gasket and the refill plug to the automatic transaxle.

4. REMOVE FRONT AXLE SHAFT NUT Removal

5. SEPARATE FRONT STABILIZER LINK ASSEMBLY Removal

6. SEPARATE FRONT SPEED SENSOR Removal

7. SEPARATE TIE ROD ASSEMBLY Removal

8. SEPARATE NO. 1 FRONT SUSPENSION LOWER ARM Removal

9. SEPARATE FRONT DRIVE SHAFT ASSEMBLY Removal

10. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

11. REMOVE TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the transaxle case oil seal.

SST : 09308-00010

12. INSTALL TRANSAXLE CASE OIL SEAL

(a) Using SST and a hammer, tap in a new transaxle case oil seal.

SST : 09316-10010

SST : 09950-70010

09951-07100

Oil seal driven in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

NOTICE:
Check that the oil seal is installed in the correct direction.

(b) Coat the lip of the transaxle case oil seal with MP grease.

13. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation

14. INSTALL NO. 1 FRONT SUSPENSION LOWER ARM Installation

15. INSTALL TIE ROD ASSEMBLY Installation

16. INSTALL FRONT SPEED SENSOR Installation

17. INSTALL FRONT STABILIZER LINK ASSEMBLY Installation

18. INSTALL FRONT AXLE SHAFT NUT Installation

19. INSTALL FRONT WHEEL

20. ADD AUTOMATIC TRANSAXLE FLUID

HINT
Procedures.

21. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK

22. INSTALL FRONT FENDER APRON SUB-ASSEMBLY LH

(a) Install the front fender apron sub-assembly LH with the 2 bolts and clip.

23. ADJUST FRONT WHEEL ALIGNMENT

HINT
Front Wheel Alignment.

24. CHECK ABS SPEED SENSOR SIGNAL

HINT
Test Mode Procedure.