Installation

REAR SUSPENSION: REAR STABILIZER BAR: INSTALLATION

1. INSTALL REAR STABILIZER BAR

(a) Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.





Text in Illustration





(b) Install the 2 rear No. 1 stabilizer bar brackets to the rear stabilizer bushings.





Text in Illustration





NOTICE:
* Ensure that the identification shape faces upward.
* Ensure that the identification mark faces the right side of the vehicle.

(c) Install the rear stabilizer bar with 2 rear stabilizer bushings and 2 rear No. 1 stabilizer bar brackets with the 4 bolts.





Text in Illustration





Torque : 75 Nm (765 kgf-cm, 55 ft-lbf)

NOTICE:
Ensure that the identification mark faces the right side of the vehicle.

2. INSTALL REAR STABILIZER LINK SUB-ASSEMBLY LH

(a) Hold the rear lower stabilizer bracket LH between aluminium plates in a vise as shown in the illustration.





NOTICE:
Do not overtighten the vise.

(b) Install the rear stabilizer link sub-assembly LH to the rear lower stabilizer bracket LH as shown in the illustration.

Torque : 90 Nm (918 kgf-cm, 66 ft-lbf)

HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

(c) Install the rear stabilizer link sub-assembly LH to the rear stabilizer bar with the nut (B).





Torque : 90 Nm (918 kgf-cm, 66 ft-lbf)

HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

(d) Install the rear stabilizer link sub-assembly LH with rear lower stabilizer bracket LH to the rear No. 2 suspension arm assembly LH with the 2 nuts (A).

Torque : 82 Nm (836 kgf-cm, 60 ft-lbf)

3. INSTALL REAR STABILIZER LINK SUB-ASSEMBLY RH

HINT
Perform the same procedure as the LH side.