Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): INSTALLATION

1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the airbag connector to the front passenger side knee airbag assembly.





NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

(d) Temporarily install the front passenger side knee airbag assembly with the claw and 2 pins.





(e) Install the front passenger side knee airbag assembly with the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

NOTICE:
Confirm that the front passenger side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.

(f) Remove the protective tape.





Text in Illustration





2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation

4. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

6. INSTALL INSTRUMENT PANEL GARNISH RH

HINT
Use the same procedure for the RH side and the LH side Installation.

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT
Use the same procedure for the RH side and the LH side Installation.

8. INSTALL FRONT DOOR SCUFF PLATE RH

HINT
Use the same procedure for the RH side and the LH side Installation.

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check Reading and Clearing Diagnostic Trouble Codes.

11. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.