Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Driver Side): INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Engage the claw to connect the hood lock control cable to the driver side knee airbag assembly.





(d) Connect the airbag connector to the driver side knee airbag assembly.

NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

(e) Temporarily install the driver side knee airbag assembly with the 2 claws and 2 hooks.





(f) Install the driver side knee airbag assembly with the 4 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

NOTICE:
Confirm that the driver side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

3. INSTALL NO. 1 SWITCH HOLE BASE Installation

4. INSTALL INSTRUMENT PANEL GARNISH LH Installation

5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

7. INSTALL FRONT DOOR SCUFF PLATE LH Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check Reading and Clearing Diagnostic Trouble Codes.

10. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.