Installation

2GR-FE ENGINE CONTROL: AIR FUEL RATIO SENSOR: INSTALLATION

1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold RH.





Text in Illustration





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 33 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The "with SST" torque value is effective when SST is parallel to the torque wrench.

(b) Connect the air fuel ratio sensor connector.

2. INSTALL AIR FUEL RATIO SENSOR NO.2 (for Bank 2 Sensor 1)

(a) Use the same procedure for bank 1 and bank 2.

SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 33 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The "with SST" torque value is effective when SST is parallel to the torque wrench.

3. INSTALL EXHAUST MANIFOLD

(a) Install the exhaust manifold Installation.