Replacement

AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT: REPLACEMENT

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Disassembly

3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG Removal

4. REMOVE REAR DISC Removal

5. REMOVE REAR AXLE HUB BOLT

(a) Temporarily install 2 nuts to the rear axle hub bolt as shown in the illustration.





Text in Illustration





Recommended service nut:

Thread diameter: 12.0 mm (0.472 in.)

Thread pitch: 1.5 mm (0.0591 in.)

NOTICE:
Install the nuts to prevent damage to the rear axle hub bolts.

(b) Using SST and a brass bar or an equivalent tool to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt.

SST : 09628-10011

NOTICE:
Do not damage the threads of the rear axle hub bolts.

6. INSTALL REAR AXLE HUB BOLT

(a) Temporarily install a new rear axle hub bolt to the rear axle hub and bearing assembly.





Text in Illustration





(b) Install a washer and nut to the new rear axle hub bolt as shown in the illustration.

Recommended service nut:

Thread diameter: 12.0 mm (0.472 in.)

Thread pitch: 1.5 mm (0.0591 in.)

HINT
The thickness of the washer is preferably 5 mm (0.197 in.) or more.

(c) Using a brass bar or an equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

NOTICE:
* Install the nuts to prevent damage to the rear axle hub bolts.
* Do not damage the threads of the rear axle hub bolts.

(d) Remove the 3 nuts and washer from the 3 rear axle hub bolts.

7. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG Installation

8. INSTALL REAR DISC Installation

9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Reassembly

10. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL Adjustments

11. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)