Reassembly

HEATING / AIR CONDITIONING: CONDENSER: REASSEMBLY

1. INSTALL COOLER DRYER

(a) Using pliers, install a new cooler dryer to the modulator.





Text in Illustration





NOTICE:
* Due to the potential of damaging the bracket, do not hold or support the bracket by hand when removing the cooler drier cap.
* When storing the condenser, do not put the brackets facing down (toward the ground) because this may cause damage to the brackets.

(b) Sufficiently apply compressor oil to a new O-ring and the fitting surfaces of the cap.





Compressor oil:

ND-OIL 8 or equivalent

(c) Using a 14 mm straight hexagon wrench, install the cap to the cooler condenser core.

NOTICE:
Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.





Torque : 2.9 Nm (30 kgf-cm, 26 in-lbf)

Text in Illustration





NOTICE:
* Due to the potential of damaging the bracket, do not hold or support the bracket by hand when removing the cooler drier cap.
* When storing the condenser, do not put the brackets facing down (toward the ground) because this may cause damage to the brackets.

2. INSTALL NO. 1 COOLER CONDENSER CUSHION

(a) Install the 2 No. 1 cooler condenser cushions as shown in the illustration.





Text in Illustration





NOTICE:
* Due to the potential of damaging the bracket, do not hold or support the bracket by hand when removing the cooler drier cap.
* When storing the condenser, do not put the brackets facing down (toward the ground) because this may cause damage to the brackets.