Reassembly

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF HOUSING: REASSEMBLY

1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

(a) Hold down the window deflector.





NOTICE:
Make sure that the spring indicated by the arrow in the illustration is securely installed.

(b) Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.





HINT
Tape the screwdriver tip before use.

(c) Engage the 2 claws and install the sliding roof drip channel.





(d) Install the 2 sliding roof side stoppers with the 2 screws.





Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

2. ADJUST FULLY CLOSED POSITION

(a) Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction as indicated by the arrows in the illustration and align the matchmarks.





Text in Illustration





HINT
Tape the screwdriver tip before use.

3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

(a) Insert the sunshade trim into the sliding roof housing sub-assembly.





(b) Install the sliding roof piece sub-assembly LH and RH with the 2 screws.





Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

4. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

(a) Install the sliding roof drive gear sub-assembly with the 2 bolts.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(b) Engage the claw and install the sliding roof drive gear bracket.