Front Passenger Side Power Mirror Cannot Be Adjusted With Power Mirror Switch

MIRROR (EXT): POWER MIRROR CONTROL SYSTEM: Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch

SYSTEM DESCRIPTION

When the mirror adjust switch is operated, the multiplex network master switch assembly detects the switch operation and sends the mirror adjust switch signal to the main body ECU (multiplex network body ECU) via LIN communication. The main body ECU (multiplex network body ECU) then sends the mirror adjust switch signal to the outer mirror control ECU assembly (front passenger side) via CAN communication. On receiving the signal, the outer mirror control ECU assembly (front passenger side) operates the vertical and horizontal mirror motors, which are built into the outer rear view mirror assembly RH, to adjust the mirror surface position.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

(a) Use the Techstream to check if the CAN communication system is functioning normally How to Proceed With Troubleshooting.

OK:

Multiplex communication DTC is not output.

NG -- GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) CAN Communication System
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (OUTER MIRROR SWITCH)

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Master Switch / Data List.

(e) Read the Data List according to the display on the Techstream.

Master Switch





OK:

On the Techstream screen, ON or OFF is displayed for each item according to the table above.

NG -- REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY Removal
OK -- Continue to next step.

3. PERFORM ACTIVE TEST USING TECHSTREAM (POWER MIRROR CONTROL FUNCTION)

(a) Enter the following menus: Body Electrical / Mirror R / Active Test.

(b) Perform the Active Test according to the display on the Techstream.

Mirror R





OK:

Power mirror operation is normal.

NG -- INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH

OK -- REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY (FRONT PASSENGER SIDE) Removal

4. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH

(a) Remove the outer rear view mirror assembly RH Removal.





(b) Apply battery voltage and check the operation of the outer rear view mirror assembly RH.

OK:





Text in Illustration





NG -- REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH Removal

OK -- REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY (FRONT PASSENGER SIDE) Removal