Removal

DOOR LOCK: REAR DOOR LOCK: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

5. REMOVE REAR DOOR ARMREST COVER Disassembly

6. REMOVE COURTESY LIGHT ASSEMBLY Removal

7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP Disassembly

9. REMOVE REAR DOOR FRAME GARNISH Disassembly

10. REMOVE REAR DOOR TRIM BRACKET Disassembly

11. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

12. REMOVE REAR DOOR GLASS RUN Disassembly

13. REMOVE REAR DOOR WINDOW REAR GUIDE SUB-ASSEMBLY Disassembly

14. REMOVE REAR DOOR REAR GUIDE SEAL Disassembly

15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

16. REMOVE REAR DOOR LOCK ASSEMBLY

(a) Using a T30 "TORX" socket wrench, remove the 3 screws.





(b) Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

(c) Remove the door lock wiring harness seal from the rear door lock assembly.





(d) Using a screwdriver, disengage the claw.





HINT
Tape the screwdriver tip before use.

(e) Remove the rear door lock remote control cable assembly.





(f) Using a screwdriver, disengage the 3 claws.





HINT
Tape the screwdriver tip before use.

(g) Remove the rear door inside locking cable assembly.