Installation

NAVIGATION / MULTI INFO DISPLAY: HARD DISK DRIVE: INSTALLATION

1. INSTALL HARD DISK DRIVE

(a) Install the hard disk drive as shown in the illustration.





NOTICE:
To reduce the chance of bending the pins, make sure to keep the hard disk drive straight when inserting it.

(b) Install the 2 screws.





2. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY WITH BRACKET Installation

3. INSTALL SHIFT LEVER ASSEMBLY Installation

4. INSTALL CONSOLE BOX Installation

5. INSTALL RADIO RECEIVER ASSEMBLY WITH REGISTER Installation

6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation

7. INSTALL INSTRUMENT PANEL FINISH PANEL Installation

8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

9. INSTALL NO. 1 SWITCH HOLE BASE Installation

10. INSTALL INSTRUMENT PANEL GARNISH LH Installation

11. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

12. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) Installation

13. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation

14. INSTALL NO. 2 CONSOLE BOX DUCT Installation

15. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

16. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CAUTION:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

18. INSPECT SHIFT LEVER POSITION

for U660E: .

for U660F: Installation.

19. ADJUST SHIFT LEVER POSITION

for U660E: .

for U660F: Installation.

20. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.