Installation

AUDIO / VIDEO: RADIO ANTENNA CORD: INSTALLATION

1. INSTALL NO. 4 ANTENNA CORD SUB-ASSEMBLY

(a) Engage the 5 clamps.





Text in Illustration





(b) Connect the connector.

(c) Engage the 3 clamps to install the No. 4 antenna cord sub-assembly.





(d) Connect the connector.

2. INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY

(a) Engage the 2 claws to install the antenna cord grommet of back door side.





Text in Illustration





(b) Engage the grommet to install the antenna cord grommet of vehicle body side.

(c) Engage the clamp.

(d) Connect the connector.

(e) Set the position of the antenna cord grommet of back door side as shown in the illustration.





Text in Illustration





(f) Set the position of the antenna cord grommet of vehicle body side as shown in the illustration.





Text in Illustration





(g) Engage the 3 clamps.





Text in Illustration





(h) Engage the 5 clamps and install the No. 3 antenna cord sub-assembly.





(i) Connect the 2 connectors.

3. INSTALL UPPER BACK WINDOW PANEL TRIM Reassembly

4. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY

HINT
Double-sided tape and tape are not available as supply parts. If the tape still has enough adhesion to secure the roof headlining and antenna cord, reuse it. If the roof headlining has been replaced with a new one, or if the tape and/or the double-sided tape is no longer sticky, apply new tape following the procedure below.

If the double-sided tape cannot be reused:

(a) Peel off the release paper from one side of new double-sided tape and apply the new double-sided tape to the position indicated in the illustration. Be careful not to touch the adhesive surface.









NOTICE:
Be sure to apply the double-sided tape carefully so that the tape will not be misaligned or come off.

(b) Peel off the release paper from the double-sided tape. Be careful not to touch the adhesive surface.

(c) Align the vehicle front side marking (yellow) on the No. 2 antenna cord sub-assembly with the vehicle front side tab on the roof headlining, and wrap the tape over the antenna cord to install it. (A)

HINT
If the tape cannot be reused, packing tape can be used as a substitute.

(d) Temporarily install the No. 2 antenna cord sub-assembly by placing it on the double-sided tape from the front of the vehicle to the point just before the extra cord storage area.

(e) Align the vehicle rear marking (yellow) on the No. 2 antenna cord sub-assembly with the tape attachment location (scribe line) of the roof headlining, and wrap the tape over the antenna cord to install it. (B)

HINT
If the tape cannot be reused, packing tape can be used as a substitute.

(f) Temporarily install the No. 2 antenna cord sub-assembly by placing it on the double-sided tape from the rear of the vehicle to the point just before the extra cord storage area.

(g) Using double-sided tape, place any excess No. 2 antenna cord sub-assembly in the extra cord storage area to finish installing the antenna cord.

HINT
Attach 3 pieces of double-sided tape to the extra cord storage area as shown in the illustration.









5. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the procedure from Install Roof Headlining Assembly Installation.

6. INSTALL ANTENNA CORD SUB-ASSEMBLY

(a) Engage 6 clamps and install the antenna cord sub-assembly.





7. INSTALL INSTRUMENT PANEL SAFETY PAD

HINT
Refer to the procedure from Install Instrument Panel Safety Pad Assembly Installation.