Heated Oxygen Sensor

INSPECT HEATER RESISTANCE OF HEATED OXYGEN SENSOR (Bank 1 Sensor 2)
a. Remove the driver's seat.
b. Take out the floor carpet.
c. Disconnect the oxygen sensor connector.
d. Using an ohmmeter, measure the resistance between the terminals +B and HT
Resistance: 11-16 Ohms at 20 °C (68 °F)
If the resistance is not as specified, replace the sensor.
Torque: 44 Nm (440 kg.cm, 31 ft.lb)
e. Reconnect the oxygen sensor connector.
f. Reinstall the floor carpet.
g. Reinstall the driver's seat.