Speedometer Gear, A/T: Service and Repair
REPLACEMENT1. Disconnect speedometer cable and remove speedometer driven gear, as follows:
a. Loosen the serrated collar with pliers. Do not lose the felt dust protector and washer.
b. Disconnect the speedometer cable.
c. Remove the bolt and locking plate. Pry out the speedometer driven gear assembly.
d. Remove the O-ring from the speedometer driven gear assembly.
e. Remove the clip and speedometer driven gear from the speedometer driven gear sleeve.
2. Remove speedometer driven gear oil seal. Using Special Service Tool (SST) 09921-00010 or equivalent, remove the oil seal.
3. Install speedometer driven gear oil seal. Using SST 09201-10000 (09201-01080) or equivalents, install a new oil seal.
Drive in depth: 25 mm (0.98 inch).
4. Install speedometer driven gear and connect speedometer cable, as follows:
a. Install the clip and speedometer driven gear to the speedometer driven gear sleeve.
b. Install a new O-ring to the speedometer driven gear assembly. Install the speedometer driven gear.
c. Install the locking plate with the bolt.
Torque: 16 Nm (12 ft. lbs.).
d. Connect the speedometer cable. Tighten the serrated collar with pliers.