Rear Suspension

Rear Stabilizer Bar Link

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the wheel and tire.




3
CAUTION: Use a wrench on the hexagon provided to prevent the ball joint rotating.
Remove the stabilizer bar link.
- Remove and discard the 2 nuts.

Installation
1 Install the stabilizer bar link.
- Tighten the nuts to 115 Nm (85 lb.ft).
2 Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).