Rear Stabilizer Bar Bushing

Rear Stabilizer Bar Bushing

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the rear bumper cover. For additional information, refer to Rear Bumper Cover
3 Remove the spare wheel and tire.
4 Raise the vehicle.
5 Remove the rear wheels and tires.




6 Remove the body mount retaining bolts.
- Remove the 8 bolts.
7
CAUTION: Only raise the body sufficiently to remove the body mounts.
Raise the body.
- Using suitable stands, raise the body to release the body mounts.




8 Remove the 2 rear body mounts.




9 Remove the stabilizer bar bushings.
- Remove and discard the 4 bolts.
- Remove the 2 clamps.

Installation
1 Install the stabilizer bar bushings.
2 Install the stabilizer bar clamps.
- Tighten the 4 retaining bolts to 62 Nm (46 lb.ft).
3 Install the body mounts.
4 Lower the body.
- Remove the stands.
5 Install the body mount retaining bolts.
- Tighten the 8 retaining bolts to 133 Nm (98 lb.ft).
6 Install the wheels and tires.
7 Lower the vehicle.
8 Install the spare wheel and tire.
9 Install the rear bumper cover. For additional information, refer to Rear Bumper Cover