Roof Opening Panel Glass

Roof Opening Panel Glass

Removal
1 Open the roof opening panel blind.
2 Open the roof opening panel to the tilt position.




3 Remove the cover.
- Repeat the above procedure for the other side.




4 Remove the roof opening panel glass.
- Remove the 2 Torx screws.
- Repeat the above procedure for the other side.

Installation
1 Install the roof opening panel glass.
- Install the Torx bolts, but do not tighten fully at this stage.
2 Align the roof opening panel glass. For additional information, refer to Roof Opening Panel Alignment Procedures