Shock Absorber And Spring Assembly [Vehicles With: Dynamic Suspension]

Shock Absorber and Spring Assembly
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

CAUTION: LH illustration shown, RH is similar.

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
For additional information, refer to Loadspace Trim Panel Luggage Compartment Trim

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
For additional information, refer to Wheel and Tire Service and Repair









WARNING: Make sure that a new nut is installed.
Bolts: 10 Nm
nut: 60 Nm





Torque to: 110 Nm





Torque to: 270 Nm









Torque to: 175 Nm





CAUTION: Note the fitted position of the component prior to removal.





Install Special Service Tool: Lever, Wheel Knuckle, JLR-204-804














CAUTION: Take extra care not to damage the wiring harnesses.





Torque to: 32 Nm





Torque to: 32 Nm





NOTE:
Do not disassemble further if the component is removed for access only.

NOTE:
Only if fitted.

Torque to: 10 Nm

Installation






NOTE:
Make sure that the component is installed to the noted removal position.
1 To install, reverse the removal procedure.