Rear Crankshaft Main Bearing Seal: Service and Repair

Crankshaft Rear Seal
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.
For additional information, refer to Flexplate Service and Repair





Installation





1 Install the special tool.
Special Service Tool




Rear Crankshaft Seal Installer, 303-1442

Special Service Tool




Rear Crankshaft Cover Alignment Tool, 303-1443





NOTE:
Tighten the bolts in the indicated sequence.

Torque to: 11 Nm





Torque to: 11 Nm
For additional information, refer to Flexplate Service and Repair