Side Parking Aid Camera Wiring Harness - Front Door Section

Side Parking Aid Camera Wiring Harness - Front Door Section

Removal





1
NOTE:
Left-hand shown, right-hand similar.
Remove the front scuff plate trim panel.
- Release the 7 clips.
2 Remove the cowl side trim panel. For additional information, refer to Cowl Side Trim Panel Cowl Side Trim Panel




3
NOTE:
Door shown removed for clarity.
NOTE:
Right-hand shown, left-hand similar.
Release the gaiter.




4
NOTE:
Right-hand shown, left-hand similar.
Disconnect the 2 electrical connectors.




5
NOTE:
Right-hand shown, left-hand similar.
Remove the gaiter mounting bracket.
- Carefully release the 6 clips.




6
NOTE:
Right-hand shown, left-hand similar.
Release the electrical connector from the bracket.
7 Remove the front door speaker. For additional information, refer to Front Door Speaker Front Door Speaker




8 Disconnect the electrical connector.

Installation





1
CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
Install the camera overlay wiring harness.




2
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
Remove the connector from the camera wiring harness.
- Remove the locking tab.
- Carefully release the clip.
- Apply suitable tape to protect the end of the camera wiring harness.




3 Using suitable tape, secure a suitable rod to the camera overlay wiring harness.




4 Carefully feed the camera overlay wiring harness through the gaiter.




5 Carefully feed the camera overlay wiring harness along the door wiring harness to the door mirror.
6
CAUTION: Make sure that the camera overlay harness is correctly routed and clear of the front door window regulator and motor. Failure to follow this instruction may result in damage to the vehicle.
CAUTION: Make sure that excessive force is not used when installing the tie straps to the wiring harness. Failure to follow this instruction may result in damage to the vehicle.
Using suitable tie straps, secure the camera overlay harness to the door wiring harness.




7
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
Install the connector to the camera overlay wiring harness.
- Remove the protective tape.
- Install the electrical connector.
- Secure the locking tab.




8 Connect the electrical connector.




9 Secure the gaiter to the gaiter bracket.





10
CAUTION: Make sure the electrical connectors are correctly installed and secured.
Secure the camera wiring harness.





11 Connect the 2 electrical connectors.





12 Secure the gaiter mounting bracket.
- Secure the 6 clips.

13 Install the LH cowl side trim panel. For additional information, refer to Cowl Side Trim Panel Cowl Side Trim Panel





14
NOTE:
Left-hand shown, right-hand similar.
Install the front scuff plate trim panel.
- Secure the 7 clips.

15 Install the front door speaker. For additional information, refer to Front Door Speaker Front Door Speaker