Sunroof / Moonroof Motor: Service and Repair

Roof Opening Panel Motor

Removal

WARNING: If the roof opening panel motor is being replaced, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panel calibration routine and reset these functions.
1 Disconnect the battery ground cable. For additional information, refer to Specifications




2 Remove the front overhead console.
- Carefully release the clips.
- Disconnect the 4 electrical connectors.




3 Remove the overhead console support bracket.
- Remove the 3 bolts.




4 Remove the roof opening panel motor.
- Remove the 3 Torx screws.
- Disconnect the electrical connector.

Installation
1 Install the motor.
- Connect and secure the electrical connector.
- Tighten the Torx screws to 4 Nm (3 lb.ft).
2 Install the support bracket.
- Tighten the bolts to 25 Nm (18 lb.ft).
3 Install the front overhead console.
- Connect the electrical connector.
- Carefully secure the clips.
4 Connect the battery ground cable. For additional information, refer to Specifications