Blower Motor Resistor (RHD AWD)

Blower Motor Resistor

Removal





1
NOTE:
Left-hand shown, right-hand similar.
Remove the driver side floor console extension.
- Remove the screw.
- Release the 2 clips.




2 Release the driver side closing trim panel.
- Remove the 4 screws.
- Remove the clip.




3 Remove the driver side closing trim panel.
- Disconnect the 2 electrical connectors.
- Release the vehicle diagnostic socket.
4 Remove the right-hand footwell duct.
- Remove the 2 screws.




5 Disconnect the blower motor resistor electrical connector.
6 Remove the blower motor resistor.
- Release the retaining clip.

Installation
1 Install the blower motor resistor.
2 Connect the blower motor resistor electrical connector.
3 Install the right-hand footwell duct.
- Install the screws.
4 Install the driver side closing trim panel.
- Attach the vehicle diagnostic socket.
- Connect the electrical connectors.
5 Secure the driver side closing trim panel.
- Install the screws.
- Install the clip.
6 Install the driver side floor console extension.
- Secure the clips.
- Install the screw.