Rear Door Window Glass: Service and Repair

Glass Replacement

NOTE:
- Put on gloves to protect your hands.

1. Remove the door trim.
2. Remove the door screen.
3. After loosening the mounting screws, then remove the delta cover (A).




4. After loosening the mounting bolt and nut, then remove the rear channel (A).




5. After loosening the mounting screws, then remove the door belt weatherstrip (A).




6. Carefully move the glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

CAUTION:
- Take care not to drop to glass and scratch the glass surface.

Tightening torque :
7.8 - 11.8N.m (0.8 - 1.2kgf.m, 5.8 - 8.7 lb-ft)




7. Installation is the reverse of removal.

NOTE:
- Roll the glass up down to see if it move freely without binding.
- Adjust the position of the glass as necessary.