Electric Oil Pump - With ISG (Idle Stop & Go) System

Removal

1. Disconnect the negative (-) battery terminal.
2. Disconnect the Electric Oil Pump (EOP) connector (A).




3. Remove the under cover (A) after lifting the vehicle with lift.

Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)




4. Remove the Electric Oil Pump (B) after removing the bolts (A-4ea).

Tightening torque:
19.6 - 25.5 N.m (2.0 - 2.6 kgf.m, 14.4 - 18.8 lb-ft)





Installation

1. Installation is the reverse of removal.

NOTE:
- Must be replaced with new O ring when assembling.
- Adding automatic transaxle fluid.