Repair Procedures

Inspection

Lighting Switch Inspection
1. With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch





Lighting Switch (Auto Light)





Lighting Switch





Dimmer And Passing Switch





Turn Signal Switch





Front Fog Lamp





Wiper And Washer Switch Inspection
1. With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.





Wiper Switch





Washer Switch





Rear Wiper & Washer Switch






Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the steering column upper and lower shrouds (A) after removing 3 screws.












3. Disconnect the light switch connector (A) and the wiper switch connector (B).




4. Remove the wiper switch (A) by pushing the lock pin (B).

NOTE:
when removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.




5. Remove the clock spring(A).




6. Loosen the screws from the multifunction switch assembly.
7. Remove the multifunction switch assembly(A) after loosening the connectors.






Installation

1. Install the wiper switch then connect the lighting switch connector.
2. Install the lighting switch then connect the wiper switch connector.
3. Install the steering column upper and lower shrouds.