W/Harness Inspection

Engine Control
P0617 Starter Cut Relay Circuit High - Inspection/Repair:_:W/Harness Inspection

Terminal & Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Control Circuit Inspection

Check Short in control circuit
1. IG KEY "OFF".
2. Disconnect Starter Relay.
3. IG KEY "ON"
4. Measure the voltage between control terminal of Starter Relay harness connector and chassis ground.

Specification :Approx 4.3V




5. Is the measured voltage within specification ?