Repair Procedures

Removal

1. Remove the cover (A).




2. Remove the center console assembly.

3. Remove the select cable (B) by removing the snap pin (A).




4. Remove the shift lever assembly (B) by removing the bolts (A-4ea).




5. Remove the shift cable (B) from the shift lever assembly by removing the clip (A).










Installation

CAUTION:
- Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
- Install the "N" position pin (A).





1. Install the shift cable (A).




2. Install the shift lever assembly (B) by tightening the bolts (A-4ea).

Tightening torque:
9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb-ft)








3. Shift the shift lever to 3rd gear.
4. Re-adjust select cable.




5. Insert the select cable (A) to the shift lever assembly pin (B).




6. After shifting 2nd gear, checking the left select gab about 1.1mm (if not, loop no.3 - 6).
7. Install the snap pin (A).




8. Remove the "N" position pin (A) after after assembling select cable. (Refuse)





NOTE:
1. Operating lever of body side, check secure operation of lever of T/M side after assembly.
2. When lever is engaged to "R", check the position of "skirt".
3. When lever is shifted to each position, if stop occur between two position, re-adjust select cable.